Dear all,
Kawasaki Gas turbine generator 8500kva 50hz 3300v, 2011,
After last overhauled on 2023 March. Abt. 23000 hours.
Fuel: Gas
| 1. "KAWASAKI"Gas turbine engine set | |||||||
| Manufactured under : ISO 9001-14000 with low Nox DLE system | |||||||
| Model: M7A-03D , | |||||||
| Type : Simple open cycle, single shaft | |||||||
| Construction: 11 stage axial compressor - 6 can type combustors 4 stage axial turbine | |||||||
| Revolution speed : 13,790 rpm., | |||||||
| Fuel : Natural gas with LHV 8,132 Kcal/Nm3 | |||||||
| Combustion method: DLE combustion (Pre-mixed lean combustion) | |||||||
| High efficiency : electric 33% overall 80% , Dry low emissions : Nox 25 ppmv, CO- 50 ppmv | |||||||
| Starting method : Electric start by inverster motor | |||||||
| Lubrication: Forced lubrication, ISO VG46 | |||||||
| Fire fighting system - CO2 system, Control of CO2 system, Piping to nozzles for CO2 system | |||||||
| 2. 3 "KAWASAKI" Turbine generator set | |||||||
| AC synchronous generator, Brush-less | |||||||
| Type : Horizontal shaft brush-less, synchronous type, air cooled | |||||||
| Speed : 1,500 rpm, 3,300 volt, 3 Phase, 4 pole , Current : 1,470 AMP., Frequency 50 Hz. | |||||||
| Power factor : 0.9 | |||||||
| Inlet cooling : 8,400 KVA. continuous @ air temp. 15 C | |||||||
| without cooling 7,859 KVA.@ air temp. 30 C. | |||||||
| Efficiency: 97% or more at rated power and power factor | |||||||
| Voltage regulation : Voltage drop at sudden increase of the rated load -30% | |||||||
| Over current capability: 150% of rated current for 30 sec. | |||||||
| 3. Waste heat recovery boiler system (HRSG.) | |||||||
| Data for the boiler : with maximum gas flow at design point | |||||||
| Exhaust gas flow from on engine : 27.14 kg/sec. | |||||||
| Exhaust gas temperature from after burner : 942 C | |||||||
| Steam generation : 40,000 kg/hr. | |||||||
| Working pressure : 17.5 bar g | |||||||
| Design pressure : 23 bar g | |||||||
| Feed water temperature : 130 C | |||||||
| Boiler heating surface approx : 827 m2 | |||||||
| Water cooler furnace : 50 m2 | |||||||
| Economizer heating surface approx : 717 m2 | |||||||
| Hot water generator (Separate circuit) approx 1,168 m2 | |||||||
| 4. Fuel gas compressor | |||||||
| Gas.Compressor | |||||||
| Manufacturer : Grasso, Screw compressor type, Model: LP-L26T-28, Speed 2950 rpm. | |||||||
| Inlet connect- NB 125, outlet -NB 80 | |||||||
| Inlet pressure 6 barg, outlet pressure 21 barg, Operating temp. 90 C | |||||||
| Required flow rate 2600 Nm3/hr. | |||||||
| Compressor motor | |||||||
| Manufacturer : WEG, Model: W21, Rate output 185 KW. 2 pole, Speed 2975 rpm., 50 Hz, | |||||||
| 5. Absorb Chiller | |||||||
| "EBARA"Chiller, Model: POW045, Manufacturing : B11V025201 | |||||||
| Refrigerating capacity 1406.8 KW., Energy source: Steam | |||||||
| CHW.Flow rate : 2,502 L/min, CHW.outlet temp. 15-7 C | |||||||
| Steam supply press 0.78 Mpa., Steam consumption 1,740 kg/hr. | |||||||
| Power supply 380 V. 50 Hz. | |||||||
| Date of Manuf. Sep.2011 | |||||||
Documents are available upon request
Price is USD200,000 FOB
Plesae advsie your interest
Best regards
Woonha Jee
We use cookies to improve your experience. By continuing to use our site, you accept our Cookies, Privacy Policy,Terms and Conditions. Close X
